Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
How to set the topcat-trap
Push the clamping lever with the attached rocker all
1.
the way upwards through the slit in the cover.
Push down the rocker onto the cover of the trap and
2.
hold down. Pull the snapper arm all the way up.
Slowly release the rocker, until the tip of the rocker
3.
touches the tip of the snapper arm.
Locking the trap
To lock the open trap, rotate the rocker 90° outwards
into locking position.
24
90°
Instructions for care
Clean the trap occasionally with water and leave to
dry. Lubricate with odourless milking grease if needed.
Spare parts
All parts can be replaced individually. Please contact
your nearest reseller.
Bringing misaligned triggers into the right position
Bring the rocker into locking position (see page 24 ).
Bring the two triggers, one after the other, in position
and hold them there with one hand. Grasp the small
hook of the snapper arm and turn clockwise until the
hook and triggers are positioned parallel to the rocker.
Functional check: set the trap and check if both
triggers (Fig. left) are positioned parallel to the rocker
(Fig. right).
EN
25
Publicité
Table des Matières
