System Set Up And Operation - Oki BVX-100 Guide De L'utilisateur

SYSTEM SET-UP and OPERATION
Remove BVX-100 from packaging materials and place on workbench where
fume extraction is necessary. Plug the power cord into the outlet on the back
of the system. Plug the power cord into a grounded wall socket.
WARNING: To provide protection against the risk of electrical shock, connect
only to properly grounded outlets.
To power the system, click the power switch located on the top left of the unit
to the "1" position. The LED light will illuminate green when system is "On." If
you plan on using the unit with an arm, install the arm prior to powering the
system (see Arm Operation for installation instructions). Test the "Blocked
Filter" LED Indicator to assure proper operation by blocking the front of the
hose or plenum. If operating properly, the LED should change from green to
orange. Once you are familiar with operating the system, you can choose
your preference of plenum or arm operation.
PLENUM OPERATION
Place the plenum in front of the work area where fume extraction is
necessary. Plug the system in and click "On." Fumes will be absorbed
collected through the opening at the bottom of the plenum. Impurities are then
removed in the filter and clean air returned to the environment.
ARM OPERATION
If you need the flexibility to move the fume collection device to the source of
the fumes, the BVX-100 easily converts for use with an arm. An arm and
adapter come with the BVX-100 system for easy conversion to arm use. Make
sure the system is "Off" and unplugged. Slide the adapter into the plenum till it
stops and secure it to the top of the plenum with the lock. Insert the cuffed
end of the arm into the adapter. Adjust the arm as needed.
www.okinternational.com
5