Condition For Instalation - RM SPI-704 E Notice D'installation Et D'emploi

CONDITION FOR INSTALLATION
The induction hob must be installed into a level surface using the installation frame. The air supply and
offtake vents must not be covered. The surface into which the cooker is to be installed must be capable of
supporting at least 100 kg. The fixtures for disconnecting the appliance from the mains must be easily accessi-
ble.
Installation regulations for the built-in model
The following points must be adhered to:
- make sure that the voltage in the mains corresponds to the data given on the appliance type sticker.
- Installation must comply with local regulations about electrical installation in buildings. The valid national
regulations about electrical appliances must be adhered to.
- The induction hob is fitted with a supply cable, which may be connected using a plug inserted into a soc-
ket.
- If a safety switch is used, it must be calibrated for short-circuits to at least I∆n = 30 mA.
- Prevent blockage of the air supply and offtake vents by items (fabric, wall, etc.)
- Prevent hot air from being drawn into the appliance from the area surrounding the induction hob (multi-
ple appliances next to each other, near the grill or oven). Otherwise an air-supply channel must be used.
- The cooker has a filter, which cleans the air draw into the appliance. In spite of this you must make sure
that the surrounding air drawn in to the induction appliance does not include greasy vapour coming from
work activities on other appliances (fryers, grills, etc.).
- The temperature of the drawn in air must be less than +35 oC.
- The users must make sure that all installation, maintenance and inspection work is carried out by the
authorised professional personnel.
- The intake air must be drawn into the channel and through the filter, which is part of the delivery, directly
to the ventilator. The cross section of the intake vent must be at least 200 cm2 per electronic unit.
- No closed air circulationmay occur. The air leaving the hob must never be drawn into the appliance again,
otherwise the hob continues to heat up.
- Installation of the appliance must be tested for reliability in practice. In order to do this you must esta-
blish the maximum temperature of the cooling radiator. This is measured on the radiator panel below the
induction spiral. The temperature must not exceed 65 oC during extended operation (at least 2 hours) and an
ambient temperature of 20 oC.
- The supply cable must be shielded with clean contacts on both ends.
- Equipment used to disconnect the cooker from the mains should be switched on and off a maximum of 5
times a day.
- Before performing maintenance or replacement of components, the appliance must be disconnected from
the power supply. If this is executed by removing the plug from the socket this must clearly be pointed out
and there must be easy access to the socket from all sides so that users can check that the plug is still out of
the socket from any position they have access. If this is not possible due to the design of the appliance or due
to the method of installation, disconnection must be secured by attaching the removed plug so that it cannot
be reinserted by mistake.
The induction hobs are equipped with a cable with plug, which meets national regulations.
Make sure that the plug is correctly attached to the cable:
The legal regulations of the specific country must be adhered to when connecting the appliance to the mains!
Warning Warning
Incorrect voltage may damage the induction hob The appliance must be connected by an expert
9