Instruction For Use; Terminating Operation - RM SPI-704 E Notice D'installation Et D'emploi

NSTRUCTION FOR USE
- Befor conection the device to electricity is very important have all knobs in position „0".
-The fi rst switching on device must be performed in a well ventilated room. The "burning of plates" takes
about 30 minutes. After these 30 minutes the device is ready for operation.
When starting operation switch on the appliance's main switch, which is located outside the appliance. During
operation control the appliance using the regulation buttonsonly. If you are not using the appliance for an
extended period, switch the main switch off .
Turn the knob (A) and adjust required performance. Pilot lamp (B) will light. Pilot lamp (B) lights when the
device is connected to the electricity and switched on. Switch the device off by turning the knob (A) into
position „0".
The pilot light will fl ash when the appliance is on, signalising that the hotplate has been switched on. The
pilot light remains lit after an item of cookware has been placed on the hotplate. A continouslylit pilot light
signalises that energy is being transferred to the cookware.
B
A
WARNING!
- ALWAYS PLACE COOKWARE IN THE MIDDLE OF THE HOTPLATE
- COOKWARE MUST NOT OVERLAP THE PERIMETER OF THE GLASS WORK SURFACE
- THE HOB ONLY WORKS WITH COOKWARE INTENDED FOR COOKING BY INDUCTION
- NEVER PLACE EMPTY COOKWARE ON THE HOB
- THE APPLIANCE ONLY RESPONDS TO CONTAINERS OF A MINIMUM DIAMETER OF 12 CM

TERMINATING OPERATION

If you are not using the induction hob, make sure that the main switch or power regulator has not
been switched on by mistake. If you are not using the hob for an extended period (several days)
remove the plug from the socket and switch the main switch off . Prevent any fl uid from entering the
hob, do not clean it using fl uids.
15