Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Lead connection for wall-mounting socket 8571/11
Main operating contacts
Table 7-1: Dimensions for stripping leads
• Open the terminal chamber cover.
• Guide the lead through the cable entry and into the terminal chamber.
• Remove the insulation jacket from the lead end.
• Clamp the stripped lead end of the wire to the corresponding terminal clamp.
ATTENTION: The stripped lead ends must be completely inserted under the terminal
clamping plate!
• Correctly orient the leads. The terminal clamps must not be subjected to tension
(pulling forces).
• Tighten the cap nut of the cable entry.
• Carefully replace the enclosure cover and screw it in place.
7.1.2 Protective-earth conductor connection
As a general rule, always connect to a protective earth conductor!
Dimensions [mm]
A
B
200
12
Installation
Coupler socket Type 8571/16
17
Publicité
Table des Matières
