Petsafe Pawz Away PWF00-14406 Manuel D'utilisation Et De Dressage page 14

To assure a proper fit, please follow these steps:
1. Using the edge of the test light tool, turn the battery door to the "off" (O) position.
2. Start with your pet standing comfortably (4A).
3. Place the receiver collar on your pet so that the PetSafe
pet's neck, touching the skin. If your pet has a long or thick coat then it may be necessary to trim the hair around the contact
points to make sure that contact is consistent.
Note: The receiver collar comes with short contact points. Long contact points are available and can be purchased through the Customer Care Center.
Please see the accessories section of this operating and training guide for more information.
4. Adjust the tightness of the receiver collar to fit your pet's neck. Check the tightness of the receiver collar by
inserting one finger between the end of a contact point and your pet's neck. The fit should be snug
but not constricting (4B).
5. Allow your pet to wear the receiver collar for several minutes, then recheck the fit. As your pet becomes more
comfortable with the receiver collar, check the fit again.
6. Once you are satisfied with the fit of the receiver collar, you may trim any excess collar strap as follows (4C):
a. Mark the desired length of the receiver collar with a pen. Allow for growth if your pet is young or grows
a thick winter coat.
b. Remove the receiver collar from your pet and cut off the excess.
c. Before placing the receiver collar back onto your pet, seal the edge of the cut collar by applying a flame along
the frayed edge.
14
logo is facing your pet's chin. Center the contact points underneath your
®
Customer Care Center 00 800 18 18 20 20
4A
4B
4C