Bartscher 120.578 Mode D'emploi page 26

Setting slicing thickness
ATTENTION!
Prior to setting up the unit, remove the plug from its socket.
Wait until all parts stop moving and the motor disconnects!
To set the cutting thickness, remove the cover and feeder opening. Turn the grooved
•
caps (B, C) (Fig. 1) on the unit's cover. Carefully remove the cover with feeder
opening.
(Fig. 1)
ATTENTION! Danger of injury!
The double sickle knife is very sharp.
While setting up the unit, be careful so as not to cut fingers or hands on the knife.
•
Screws holding the spacer are located at the
front.
•
The separator establishes the thickness of the
slices.
•
Remove the screws and adjust the spacer to set
the desired thickness (Fig. 2):
up → thinner slices;
down → thicker slices.
•
The range of slice thickness can be set from 5–
35 mm.
•
After completing adjustments, replace the
screws.
•
Replace the unit's cover and attach the grooved
caps.
•
The unit is now ready for use.
- 24 -
(Fig. 2)