DeWalt DCL510 Guide D'utilisation page 10

SAVE THESE INSTRUCTIONS
FOR FUTURE USE
COMPONENTS (Fig. 2)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Battery pack E. Pivoting head
B. Release button
C. Switch G. Magnets
D. Stand
FIG. 2a
C
D
B
A
E
OPERATION
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect battery pack before making any
adjustments or removing/installing attachments or accessories.
Installing and Removing the
Battery Pack (Fig. 3)
NOTE: Make sure your battery pack is fully charged.
To install the battery pack (A) into the worklight, align the battery pack
with the rails inside the handle and slide it firmly into place until you
hear the lock snap into place.
F. Belt hook
FIG. 2b
F
FIG. 3
B
A
To remove the battery pack from the worklight, press the release
button (B) and firmly pull the battery pack out of the handle. Insert it
into the charger as described in the charger section of this manual.
Switch (Fig. 2a)
To turn the light on, press the switch (C). To turn it off, press the switch
again.
Magnets, Belt Hook and Stand (Fig. 2)
CAUTION: When magnet and belt hook is in use, do not shake
light. Personal injury or property damage may occur.
CAUTION: When light is hung by the magnet and belt hook, do not
G
shake the light or object that it is hanging from. Do not hang the light
from any electrical wires or anything that it is not secure. Personal
injury or property damage may occur.
CAUTION: Only use the magnet and belt hook for hanging the
LED worklight. The magnet and belt hook are not intended to support
additional weight. Do not attach or hang anything additional to the
light or risk of breakage may occur.
CAUTION: Do not use the magnet and belt hook to reach with
or use the magnet and belt hook to support your weight in any
situation.
Using the stand (D), belt hook (F) and magnets (G), the worklight can
be placed in multiple locations for ideal lighting.
The kickstand should be snapped into the home position if not in use,
as shown in Figure 2a.
8