Aqua Medic aquarius control Mode D'emploi page 5

In purchasing this aquarius control, you have selected a top quality product. It has been specifically designed for
aquarium use and has been tested by experts.
Programmable light control for Aqua Medic aquarius
1. Technical Data
- 24 V safety voltage
- dimensions: 11.0 x 6.0 x 2.5 cm
2. Unpacking
On unpacking, please check the light control immediately for any damage. In case of any problems, please contact
your dealer directly.
3. Included in shipment
aquarius control

A 'Y'-cable for connecting two aquarius lights to one control unit is available as an accessory.
4. Safety instructions
- When working in the aquarium, always disconnect all units from the power supply system before putting your
hands into the water. Connect all units to the mains via a residual current device with a maximum residual
current of 30 mA.
- Suitable for indoor use only.
- Protect the power supply and controller from moisture, splash and condensate.
- Not suitable as a toy for children.
5. Installation
5.1. Programming
The aquarius control may only be used with the designated socket (pict. No. 1) of an aquarius. The internal
battery will need to be charged before use. After charging, the controller can be switched on independently from
the light by pressing the "M" and "OK" buttons simultaneously.
Fig. 1: Socket for aquarius control
Buttons:
M: menu
OK: confirm
＋
up
－
down
5
Operation Manual ENG