Operating The Revolving Console; Initial Operation - HASE Bari Mode D'emploi

5.

Operating the Revolving Console

The Bari is equipped with a rotating console.
Just lift the handle (a) to release the latch and then rotate the
Bari to the desired position. (Not applicable if Hase ventilati-
on system is used.) When installing the Bari, ensure that the
score (b) faces towards the front (Fig. 3).
a
fi g. 3
WARNING!
Always comply with the safety distances to
combustible and fl ammable materials!
Never turn stove when lighting fi re!
34
fi g. 4
b
fi g. 5
fi g. 6

6 . Initial Operation

NOTE!
During shipment, condensation moisture can
accumulate in the stove's interior, which may
possibly lead to the appearance of
condensation or water on the stove or fl ue
pipes. Please dry off these damp areas imme
diately.
The surface of your stove was treated in a sandblasting
machine before applying the colour coating. Despite careful
and thorough inspection, there may still be some residual
material in the stove body, which can fall out when your stove
is being installed.
NOTE!
To prevent any damage, please immediately
vacuum up these small steel pellets with a
vacuum cleaner.
The fi rst time a stove is operated, the heat development causes
the emission of volatile components from the coating, sealing
strips and lubricants, and smoke and odours can occur.
At a higher combustion temperature, this one-time process can
take between 4 to 5 hours.
To achieve this higher combustion temperature, please incre-
ase the fuel quantity recommended
in Section 7, „Adding Fuel/ Heating with Nominal Thermal
Output", by approximately 25%.
CAUTION!
To prevent adverse effects on health, nobody
should stay in the room(s) during this process