Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
While warming up, the current temperature can be displayed by pressing the
button.
A running program can be stopped at any time. A program stop is triggered by press-
ing the
button.
appears in the display.
Stop must be confirmed within 5 s by pressing the
button again, otherwise the
program continues to run.
At the end of a program, a signal tone sounds and
appears in the display.
Press one of the following buttons (
,
,
) to call up the last program
again.
Graphic-mode
Press the graphic to zoom in and out.
Press the
button to go back to the start display.
®
If you use the NANOCOLOR
VARIO 4 in the graphic mode (see menu, graphic-
mode), press
to switch between the temperature curves of the two blocks.
14
www.mn-net.com
Publicité
Table des Matières
