Reel Mower General Arrangement; Contents Of The Shipping Container; Assembly Instructions - Masport Olympic Reel Mowers 400 Manuel D'utilisation

OPC (Operator Presence
Control) bail
Throttle lever
Fuel cap
Air cleaner
assembly
Choke control
lever
Pull start cord
Ignition switch
Lower handle
fastening bolts
Engine oil filler plug
Grass deflector
adjuster bolts
Cutting reel/bottom
blade adjuster—
not visible

Contents of the shipping container

In the carton you will find...
• One reel mower— assembled.
• One grass catcher.
• Upper and lower handle assembly.
• Owner's Manual— this publication.
• Engine Owner's Manual.
• The Masport Express Warranty card.
• 4 Plastic cable ties.
• 6mm Nut and bolt for Roller clutch cable adjuster.

Assembly Instructions

LOWER HANDLE.
To facilitate shipping the handle is not attached to the mower. It has
two parts, an upper and a lower one. Fit the lower handle (the one
without a hand grip) first. It does not matter which way around it is
fitted. Bolt it loosely to the lugs at the rear of the mower using the
four bolts provided. Note that the lower bolts pass through slots to
provide adjustment for the handle height. After fitting the upper
handle, adjust it to the desired height and tighten all four bolts firmly
031992 - Masport European Reel Mower Owner's Manual - July '10

Reel Mower General Arrangement

Grass catcher
Roller clutch bail
Upper handle
Roller clutch cable
adjuster
Shaft cover
Cam lock lever
Lower handle
Catcher handle
UPPER HANDLE.
Keeping the upturned handle grip on top, fit the lower ends of the
top handle over the bottom handle and align the holes for the cam
locks.
Remove the nut and washer from the cam lock bolt but leave the
rectangular wear plate in position as you pass the bolt through the
holes from the outside. The flattened part of the bolt fits the slot in
the upper handle. While the cam locks will work with the bolt fitted
either way in the slot, we suggest fitting the bolt so that the cam
lock handle will point to the top of the handle when locked. Fit the
washer and nut on the inside of the bolt and adjust the nut to give
the desired clamping action. Fit the second cam lock in the same
way.
Chain cover
Cutting height
adjustment hand-
wheel—
not visible
5