Table des Matières
Publicité
GENERAL
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
WARNING
Do not, at any time, let brake fl uids, gasoline, petroleum-
based products, penetrating oils, etc. come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
Electrical tools used on fi berglass material, wallboard,
spackling compounds, or plaster are subject to accelerated
wear and possible premature failure, because the fi berglass
chips and grindings are highly abrasive to bearings,
brushes, commutators, etc. We do not recommend using
the product for extended work on these types of materials.
WARNING
Always wear safety goggles or safety glasses with side
shields during power tool operation. If operation is dusty,
also wear a dust mask.
If the power supply cord is damaged, it must be replaced
only by the manufacturer or by an authorised service centre
to avoid risk. Contact authorised service centre.
For greater safety and reliability, all repairs should be
performed by an Authorised Ryobi Service Centre.
LUBRICATION
All of the bearings in the product are lubricated with a
suffi cient amount of high grade lubricant for the life of
the unit under normal operating conditions. Therefore, no
further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories, and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety Alert
V
Volts
Hz
Hertz
Alternating current
W
Watts
no
No-load speed
min¹־
Revolutions or reciprocations per minute
Class II tool, double insulation
2
| English
CE Conformity
EurAsian Conformity Mark
Ukrainian mark of conformity
Pad size
Orbital diameter
Please read the instructions carefully before
starting the product.
Wear ear protection.
Wear eye protection.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
SYMBOLS IN THE MANUAL
Connect to the power supply.
Disconnect from the power supply.
Note
Speed, minimum
Speed, maximum
The following signal words and meanings are intended to
explain the levels of risk associated with this product:
DANGER
Indicates an imminently hazardous situation, which, if not
avoided, will result in death or serious injury.
WARNING
Indicates a potentially hazardous situation, which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation, which, if not
avoided, may result in minor or moderate injury.
Publicité
Table des Matières
