Batterydetails
Ba tt e r y d et a ils
The Skyhopper remote controller requires 4 x "AA" size batteries . Install them as
follows:
1 .
Open the battery
compartment on the remote
controller using a Phillips
screwdriver (not included)
to remove the screw on the
battery compartment cover .
2 .
Insert the batteries according
to the diagram . Ensure that
the positive and negative
polarities match the
illustrations inside the battery
compartment .
3 .
Replace the battery compartment cover and replace the screw using the
screwdriver . Do not over-tighten .
Important battery information
•
Use only fresh batteries of the required size and recommended type
•
Do not mix old and new batteries, different types of batteries [standard (Carbon- zinc), Alkaline or rechargeable] or
rechargeable batteries of different capacities
•
Rechargeable batteries are only to be charged under adult supervision
•
Respect the correct polarity, (+) and (-)
•
Do not try to recharge non-rechargeable batteries
•
Do not dispose batteries in a fire
•
Replace all batteries of the same type/brand at the same time
•
The supply terminals are not to be short-circuited
•
Remove exhausted batteries from the remote control
•
Batteries should be replaced by adults
•
Remove batteries if the remote control is not going to be played with for some time
Important safety precautions
•
Never fly or follow Skyhopper in the streets
•
Keep Skyhopper away from faces and eyes
•
Do not launch at people or animals
•
Only use the charger included in this package to recharge Skyhopper
•
Keep fingers away from Skyhopper moving joints when in use
•
Make sure people around you are aware you are playing with the Skyhopper
•
Do not fly near walls or ceilings
•
Do not fly the Skyhopper near overhead cables, trees, buildings or any other obstructions
•
Do not play outdoors during thunderstorms or other adverse weather conditions
6
1.5V
1.5V
1.5V
1.5V
LR6
LR6
LR6
LR6
UM3
UM3
UM3
UM3
"AA"
"AA"
"AA"
"AA"
Battery
compartment
door