dosatron D 20 S Manuel D'utilisation page 38

ASSEMBLING THE DOSATRON (cont...)
All models
- Remove the nuts (Fig. 2-A) and ferrules (Fig. 2-C) from the
Dosatron inlet and outlet.
- Remove the plastic caps (Fig. 2/3-B) which block the inlet and
outlet of your Dosatron before connecting to the water supply.
- Make sure the watertight seals at the inlet and outlet of the Dosatron
are correctly positioned.
- Make certain that the water flows in the direction of the arrows on the
pump body.
- Wrap the thread of the nipple with teflon.
- screw the nipple (Fig. 3-M) into the vacuum breaker (Fig. 3-V).
- screw the whole assembly onto the dosing unit (Fig. 3).
NOTE : the Dosatron is shipped in oFF position (see § "Incorporated
bypass").
Automatic anti-siphon device
- screw the nipple (Fig. 3-M) into
the anti-vacuum valve (Fig. 3-V).
- screw the assembly onto the dispenser (Fig. 3).
Fig. 3
A C
B V
©
DosatRoN INteRNatIoNaL / 38
Fig. 2
B
Fig. 3
M
B