Stopping The Engine; High Altitude Operation - Ryobi RYi1000 Manuel D'utilisation

STOPPING THE ENGINE

See Figures 7 - 8.
 Remove any load from the generator.
 Put the on/off switch/fuel valve in the OFF (O) position.
 Close the vent on the fuel cap by rotating the fuel cap
lever to the CLOSED (O) position.
NOTE: If the temperature is above 75˚F, leave the vent
on the fuel cap open to relieve pressure.
To stop the engine in an emergency situation:
 Put the on/off switch/fuel valve in the OFF (O) position.
WARNING:
While operating and storing, keep at least 3 feet of
clearance on all sides of this product, including overhead.
Allow a minimum of 30 minutes of "cool down" time
before storage. Heat created by muffler and exhaust
gases could be hot enough to cause serious burns and/
or ignite combustible objects.
OPERATION

HIGH ALTITUDE OPERATION

Your engine is configured for operation below 1500 feet
altitude at the factory. Your engine must be reconfigured for
operation above 1500 feet altitude. Operating the engine
with the wrong engine configuration at a given altitude may
increase its emissions, decrease fuel efficiency, degrade
performance, and cause irreversible damage. Engines
configured for high altitude operation cannot be operated
in standard altitude conditions. A qualified service center
should ensure that your engine is properly configured for
your location.
14 — English