Ryobi RYi1000 Manuel D'utilisation page 11

FUEL CAP WARNING
Never remove fuel cap when unit is running. Shut
off engine and allow the unit to cool at least five
minutes. Remove cap slowly to release any pressure
built up in the fuel system and to avoid the heat
from the muffler igniting fuel vapors.
GROUNDING WARNING
This generator does not include a ground rod
or copper wire. Call a qualified electrician
for local grounding requirements.
HOT SURFACE WARNING
Do not touch the muffler or aluminum
cylinder of the engine. They are very HOT
and will cause severe burns. Don't put any
flammable or combustible materials in the
direct path of the exhaust.
SYMBOLS
ENGINE LUBRICANT WARNING
You must add lubricant before first operating the generator.
Always check the lubricant level before each operation. The
lubricant level should always register between the hatched
areas on the dipstick. The unit is equipped with a sensor
which will automatically shut off the engine if the lubricant
level falls below a safe limit.
CLEARANCE WARNING
While operating and storing, keep at least 3 feet of clearance on all
sides of this product, including overhead. Allow a minimum of 30
minutes of "cool down" time before storage. Heat created by muffler
and exhaust gases could be hot enough to cause serious burns and/
or ignite combustible objects.
SPARK ARRESTOR
Operation of this equipment may create sparks that can start fires
around dry vegetation. A spark arrestor may be required. The operator
should contact local fire agencies for laws or regulations relating to
fire prevention requirements.
7 — English