Ryobi RLT30CESC Manuel D'utilisation page 25

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Engine will not start.
Engine starts but will not
accelerate.
Engine starts but will only run
at high speed at half choke.
Engine does not reach full
speed and emits excessive
smoke.
English(Original instructions)
POSSIBLE CAUSE
1. No spark.
2. No fuel.
3. Engine is flooded.
4. Starter rope is harder to
pull now than when it was
new.
5. Old fuel
Engine
requires
approximately three minutes
to warm up.
Carburetor
requires
adjustment.
1.
Check
lubricant
fuel
mixture.
2. Air filter is dirty.
3. Spark arrestor screen is
dirty.
22
SOLUTION
1. The spark plug may be damaged, remove it and
check for dirt and cracks. Replace with a new spark
plug.
2. Push primer bulb until bulb is full of fuel. If bulb
does not fill, primary fuel delivery system is blocked.
Contact a servicing dealer. If primer bulb fills, engine
may be flooded, proceed to next item.
3. Remove spark plug, turn unit so spark plug hole
is aimed at the ground. Rotate the choke dial to "
" position and pull starter cord 10 to 15 times. This
will clear excess fuel from engine. Remove any fuel
which splashed on the product. Clean and reinstall
spark plug. Clean up any spilled fuel and move at
least 9m away before restarting. Pull starter three
times with choke dial at "
start, rotate choke dial to "
normal starting procedure. If engine still fails to start,
repeat procedure with a new spark plug.
4. Contact a servicing dealer.
5. Only use fresh fuel mixed with recommended oil.
Fuel over 30 days old may prevent the unit from
starting.
Allow engine to completely warm up. If engine
does not accelerate after three minutes, contact a
servicing dealer.
Contact a servicing dealer.
1. Use fresh fuel and the correct 2-stroke lubricant
mix.
2. Clean air filter. Refer to Cleaning the Air Filter
earlier in this manual.
3. Contact a servicing dealer.
". If engine does not
" position and repeat

Publicité

Table des Matières
loading

Table des Matières