Telcoma Automations T124 Instructions Pour L'installation page 39

GB
PROGRAMMING WORK and PAUSE TIMES
During programming the control unit has a self-learning capability with regard to work and pause times.
The S/S command will be activated several times during programming (item 10 of Fig. 1), alternatively the
Pp command can be used (terminal 16 if Fig. 2 or the remote control (if stored).
Important notes before programming:
A.Power the control unit and check correct operation of the control inputs through the relative LEDs (the
N.C. contact LEDs should be on).
B.Free the area of gate movement.
Pre-calibration or check procedure can be made on the magnetic limit switches during programming.
Procedure:
- Release the motor. The gate must move freely
- Enter "pause and work time programming" and proceed through to point 5
- Manually move the gate in the vicinity of the limit stops
When the control unit detects the magnet, led LD1 and the indicator lamp flash.
- make calibrations as required
- block the motor and proceed with point 6, or reset to exit programming mode.
For precise stopping at the limit stop positions, enable the deceleration interval.
Programming:
STOP
A
A
STOP
B
B
STOP
1- Manually move the gate to mid-stroke.
2- Press and hold PROG to reset, and use a screwdriver to short the jump Reset (detail 9 of fig. 1).
3- Keep the Prog key pressed.
4-After three seconds led LD1 (and indicator lamp) turns on.
5) - Programming procedure activated
6) - Press the S/S button to start the self-learning process.
7A, 7B) - The motor performs a brief manoeuvre to check correct direction of rotation.
8A.9A) - If gate closing is activated presses S/S again to complete the manoeuvre.
STOP STOP
LD1
STOP
STOP
LD1 LD1
A
B
13 14
LD1
STOP
39