DeLonghi HFS50D15 Mode D'emploi page 11

- Always use the appliance stand alone
on the floor and in an upright position.
- To disconnect heater, turn controls to
off, then remove plug from outlet.
- Connect to properly polarized outlets
only.
- This heater is not intended for use with
an extension cord or outlet strip. Plug
the cord directly into an appropriate
wall receptable.
- Check that neither the appliance nor
the power cable have been damaged
in any way during transportation.
- Make sure that no pieces of polystyrene
or other packaging material have been
left on the appliance.
It may be necessary to pass over the
appliance with a vacuum cleaner.
- When switching on the appliance for
the first time, allow it to run at full
power for at least two hours to get rid
of the unpleasant smell.
Make sure that the room in which the
appliance is located is well ventilated
during this operation. It is normal for
the appliance to emit small cracking
sounds when you turn it on.
- Do not use the appliance in rooms
with a floor area of less than 4mq (43
square feet).
- Before putting the appliance away,
make sure it is completely off and
unplugged from the outlet. Wrap the
cable around the base.
Do not store in dusty atmospheres.
- Do not rest anything on the appliance.
- Do not obstruct the air intake and
outlet grilles (danger of overheating).
- Do not place the heater near a bed
because objects such as pillows or
blankets can fall off the bed and be
ignited by the heater.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
GFI SAFETY PLUG (Appliance Leakage Current Inter-
rupter)
This device provides protection
against electric shock due to ground
fault currents by automatically shut-
ting off the power. To test the opera-
tion of the GFI Safety Plug , switch the
heater ON at either the 1 or 2 setting. Press the TEST button on
the GFI Safety Plug located at the end of the power cord. The
heater and fan should stop operating and the Power Light should
be extinguished. Press the RESET button on the GFI Safety Plug
to resume normal operation of the heater. This device should not
be used as on ON/OFF operation switch. "CAUTION: ALTHOUGH
THIS DEVICE IS PROVIDED WITH PROTECTION WHICH REDUCES
THE RISK OF ELECTRIC SHOCK, THIS PRODUCT SHOULD NEVER BE
USED CARELESSLY NEAR WATER."
DESCRIPTION
A
Thermostat
+
" ": maximum ambient temperature
*
" ": frost prevention mode
B Timer
C Function selector
" ": fan mode
"0": OFF
"1": minimum power operation
"2": medium power operation
"3": maximum power operation (certain models only)
D Indicator light
OPERATION AND USE
Electrical connection
Before plugging the appliance into the mains socket, check
that the mains power supply corresponds to the value
indicated on the rating plate and that the mains
Installation
The appliance can be used on any horizontal stable surface.
Do not overload the electrical circuit.
Avoid using the same socket for other appliances.
11