DeLonghi HFS50D15 Mode D'emploi page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

during operation. Do not use the
appliance in areas where gasoline,
paints, or other flammable liquids are
used or stored.
- Use this heater only as described
in this manual. Any other use not
recommended by the manufacturer
may cause fire, electric shock, or injury
to persons.
- To prevent overload and blown fuses, be
sure that no other appliance is plugged
into the same outlet (receptacle) or
into another outlet (receptacle) wired
into the same circuit.
- Make sure that the plug is fully inserted
into the outlet.
Wall outlets may deteriorate with
time, so check the plug periodically for
signs of overheating or deformation. If
the outlet has deteriorated, stop using
it and have it repaired.
- Do not use the appliance in small
rooms when they are occupied by
persons that are not capable of leaving
the room, unless constant supervision
is provided.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
- WARNING:
overheating,
any circumstances cover the
appliance during operation as this
would lead to a dangerous rise in
temperature, and risk of fire.
- Do not use the appliance on soft
surfaces, such as beds, where the
openings may become blocked.
- This heater is hot when in use. To
prevent burns, do not let bare skin
touch hot surfaces. Use handle when
To
avoid
never
under
moving this heater. To prevent burns,
do not touch hot surfaces with bare
skin. Use the handle when moving the
appliance.
Keep all flammable materials, such
as furniture, pillows, bedding, paper,
clothing, and curtains at least 90 cm
(3 feet) from the front and top of the
appliance also avoid contact with the
sides and back.
- Do not run cord under carpeting.
Do not cover cord with throw rugs,
runners, or the like. Arrange cord away
from traffic area and where it will not
be tripped over.
- It is normal for the heater's plug and
cord to feel warm to the touch. A plug
or cord which becomes hot tothe touch
or becomes distorted in shape may be
a result of a worn electrical outlet.
Worn outlets or receptacles should be
replaced prior to further use of the
heater.
Plugging heater into a worn outlet /
receptacle/ may result in overheating
of the power cord or fire.
- WARNING: Do not cover the appliance
while it is functioning in order to avoid
overheating which may cause risk of
fire.
Symbol meaning
This simbol indicates:
(If provided) Class II equipment
Please note:
This symbol indicates recommendations and important
information for the user.
- If your appliance is equipped with a
polythene tape used as carry handle,
remove it before connecting appliance
to the outlet.
10

Publicité

Table des Matières
loading

Table des Matières