Fermax Kit Way Manuel D'installation Et Utilisation page 36

14. Setup
14.1 Unlock Time Setting
Power up within 5 seconds,
press and hold the "B"
button for 3 seconds, this
will enter the setting menu.
backlight indicator
(blinking)
Note:1. There are two ways to set the unlock time:
a) From monitor: explained in section 12.3 of the manual.
b) From doorpanel: explained in section 14.1 of the manual.
2. During timing, the backlight indicator blinking once per second, tone beeps
once per second. Less than one second by one second calculation.
-15-
A
beep + beep
B
A
Note: For 1 way doorstation, open front
cover to fi nd button B.
Within 5 seconds, press and hold the
"A" button for 3 seconds, this will
enter the lock time settings.
backlight indicator
(off )
Press and hold the "B" button for the
time required. The length of the press
will equal the door release time (range
1~99s).
backlight indicator
(blinking once per second) beep once per second
beep