Bresser 33-10100 Manuel De L'utilisateur page 35

a) Press or to select the settings mode.
b) Press OK to access the settings menu.
c) Press or to select video length.
d) Press or to change the time period to 10 sec-
onds.
e) Press OK to save the current setting. A red dot will
now indicate your selection.
f) Press or to select the menu item „Quit".
g) Press OK to quit the settings mode.
4.1.10 Set triggering interval time
The following paragraphs describe how to set the trig-
gering interval to 5 minutes.
a) Press or to select the settings mode.
b) Press OK to access the settings menu.
c) Press or to select INTERVAL.
d) Press or to change the value to 5 Min (minutes).
e) Press OK to save the current setting. A red dot will
now indicate your selection.
f) Press or to select the menu item „Quit".
g) Press OK to quit the settings mode.
4.1.11 Set PIR sensitivity
Note: It is recommended to use the NORMAL (Middle)
mode.
The following paragraphs describe how to set the
sensitivity.
a) Press or to select the settings mode.
b) Press OK to access the settings menu.
c) Press or to select SENSE LEVEL.
d) Press or to set the PIR sensitivity to LOW, Middle
or High.
e) Press OK to save the current setting. A red dot will
now indicate your selection.
f) Press or to select the menu item „Quit".
g) Press OK to quit the settings mode.
4.1.12 Set date and time stamp
The following paragraphs describe how to activate and
deactivate the date and time stamp.
a) Press or to select the settings mode.
b) Press OK to access the settings menu.
c) Press or to select TIME STAMP.
d) Press or to select yes (on) or no (off).
e) Press OK to save the current setting. A red dot will
now indicate your selection.
GB
35