Video Mode - Bresser 33-10100 Manuel De L'utilisateur

4.1.2 Set camera mode
a) Press or to select picture mode.
b) Press „OK" to confirm your selection.
c) Remove the handbox cable from the camera.
d) The Status LED (red) flashes for approx. 60 seconds.
These 60 seconds are intended as a buffer for you to
bring the camera in position.
e) After this time, the device starts to automatically
record images, according to the selected mode.
f) If the camera is turned off and you switch it back on
again at a later time, the camera will automatically
start with the recording of images.

4.1.3 Video mode

a) Press or to select video mode.
b) Press „OK" to confirm your selection.
c) Remove the handbox cable from the camera.
d) The Status LED (red) flashes for approx. 60 seconds.
These 60 seconds are intended as a buffer for you to
bring the camera in position.
e) After this time, the device starts to automatically
record videos, according to the selected mode.
f) If the camera is turned off and you switch it back on
again at a later time, the camera will automatically
start with the recording of videos.
4.1.4 Set menu language
a) Press or to select settings mode.
b) Confirm your selection by pressing „OK".
c) Press or to select the menu item „Language".
d) Press or to select your desired menu language.
e) Confirm your selection by pressing „OK". A red dot
indicates your choice.
f) Press or to select the menu item „Quit".
g) Press „OK" to leave the settings mode.
4.1.5 Format SD-Card
ATTENTION
The system will delete all images or videos stored in the
SD-card after formatting, make sure that you have made
a backup of important data.
a) Press or to select the settings mode.
b) Press MENU OK to access the settings menu.
c) Press or to select FORMAT.
d) Press or select YES and confirm your selection
with OK.
e) Press OK to start formatting your SD-card.
f) Press or to select the menu item „Quit".
g) Press OK to quit the settings mode.
GB
33