Technical Specifications - Velleman WB032 Mode D'emploi

• Pre-drill the holes (± 30mm deep) using a power drill and a 3mm wood bit.
Fix the bracket to the wall using two lag bolts (O) and washers (Q).
•
Concrete or Brick Support
Choose an installation spot able to support the weight of the bracket and the screen.
•
Use the bracket (L) as a template to mark the three hole locations (see diagram 1b).
•
• Check for electric lines or pipes.
• Make sure the holes are level.
Drill the holes (± 60mm deep) using a power drill and a 10mm masonry bit.
•
Insert a nylon plug (P) in each hole.
•
Fix the bracket to the wall using three lag bolts (O) and washers (Q).
•
Mounting the rails on the LCD
Align both rails and fix them to the back of the LCD using the appropriate M4, M5, M6 or M8 screws and the
•
appropriate washers (see diagram 2 & 2a).
• You might need to use spacers or extra washers (J or K) with LCDs with curved or recessed back panels
(see diagram 2b & 2c).
Mounting the LCD onto the bracket
First open the hooks as shown in diagram 3a.
•
Hook both rails (M and N) over the bracket as illustrated (see diagram 3b).
•
Note: this operation should be done by 2 adult persons!
•
7.

Technical Specifications

LCD/plasma size
max. load
tilt
TV to wall
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device.
For more info concerning this product and the latest version of this manual, please visit our website
www.velleman.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 02 – 21/10/2013
WB032
32"-60" / 81-152 cm
30 kg / 66 lbs
-15° to 0°
20 mm
2.3 kg
8 ©Velleman nv