EDM Product 08710 Manuel D'instructions page 36

High pressure washer
Trouble shooting
Symptom
Machine refuses to start
Fluctuating pressure
Machine stops
Fuse blows
Machine pulsating
Machine often starts
and stops by itself
Machine starts but no
water comes out
Environmental Pro tection
This product is marked with the selective sorting symbol on waste electrical and electronic equipment. This means
that this product should not be disposed of with household waste but must be supported by a collection system in
accordance w ith D irective 2 012/19/UE. I t will t hen be r ecycled or d ismantled to m inimize impacts on t he
environment, electrical and electronic products are potentially hazardous to the environment and human health due
to the presence of hazardous substances.
EN
Cause
· Machine not plugged in
· Defective socket
· Fuse has blown
· Defective extension cable
· Pump is sucking air
· Valves dirty, worn out or stuck
· Water supply not sufficient
· Pump seals worn
· Fuse has blown
· Incorrect mains voltage
· Thermal sensor activated
· Nozzle partially blocked
· Fuse too small
· Amperage increase
· Air in inlet hose/pump
· Inadequate supply of mains water specifications required
· Nozzle partially blocked
· Water filter blocked
· Hose kinked
· Pump and/or trigger gun is leaking
· No water supply
· Water filter blocked
· Nozzle blocked
Instruction manual
Recommended action
· Plug in machine.
· Try another socket.
· Replace fuse.
· Switch off other machines
· Try without the extension cable.
· Check that hoses and connections are airtight
· Contact your nearest service centre
· Increase water pressure, check for blockage of garden hose and/
or change to bigger hose.
· Replace fuse. Switch off other machines.
· Check that the mains voltage corresponds to specification on
the name plate.
· Leave the machine for 5 minutes to cool down
· Clean the nozzle with a needle and by spraying water backwards
through the nozzle
· Change to an installation higher than the amperage con-
sumption of the machine.
· Try without the extension cable
· Allow machine to run with open trigger until regular wor-
king pressure resumes.
· Increase water pressure, check for blockage of garden
hose and/or change to bigger hose.
· Clean the nozzle with a needle and by spraying water
backwards through the nozzle.
· Clean the filter
· Straighten out hose
· Contact your nearest service centre
· Connect inlet water.
· Clean the filter
· Clean the nozzle with a needle and by spraying water bac-
kwards through the nozzle
Ref: 08710