EDM Product 08710 Manuel D'instructions page 33

High pressure washer
Operating instructions
Mounting of high pressure hose
1. Attach the high pressure hose (10) to the trigger gun (11)
and machine.
Detach the high pressure hose by pressing the pawl (A) or
button (B)
Mounting of lance and nozzle
1. Push the lance (13) into the trigger gun (11)
2. When inserted turn it. Caution: Make sure the lance (13) is
properly fixed to the gun (11)
3. Attach the nozzles (14-19). Caution: When attaching the
nozzle (14-19) the button (A) on the nozzle (14-19) should
come out again. Check before activating the trigger that
the nozzle (14-19) is properly fixed.
Water connection
An ordinary 1/2" garden hose of min. 10 m and max. 25 m
will be suitable.
IMPORTANT! Only use water without any impurities. If the-
re is a risk of sand particles in the inlet water (i.e. from your
own well), an additional filter should be mounted.
1. Let the water run through the water hose before connec-
ting it to the machine to prevent sand and dirt from pene-
trating the machine. Note: Check that the filter is fitted in
the water inlet pipe and that it is not clogged up.
2. Connect the water hose to the water supply by means of
the quick connector (inlet water, max. pressure: 10 bar, max.
temperature: 40°C).
3. Turn on the water .
Start/stop of the machine
The trigger gun (11) and lance (13) is affected by a thrust
EN
Instruction manual
during operation therefore always hold it firmly with both
hands.
IMPORTANT: Point the nozzle at the ground.
1. Check that the machine is in upright position.
NOTE: Do not place the machine in high grass!
2. Release the trigger lock (12)
3. Activate the trigger of the trigger gun (11) and let the wa-
ter run until all air has escaped from the water hose.
4. Press the Start/stop switch (5).
5. Activate the trigger of the trigger gun (11).
6. Always adjust the distance and thus the pressure of the
nozzle to the surface, which is to be cleaned.
Do not cover the machine during operation or use it in a
room without adequate ventilation!
NOTE: If the machine is left or not used for 5 minutes, it
must be switched off on the start/stop switch (5) "O":
1. Press the start/stop switch (5) "O"
2. Disconnect the electrical plug (2) from the socket.
3. Shut off the water supply and activate the trigger of the
trigger gun (11) to relieve the machine of pressure.
4. Lock the trigger gun (11)
When releasing the trigger of the trigger gun (11), the
machine automatically stops. The machine will start again
when you reactivate the trigger gun (11)
Multi Nozzle
The pressure can for the multi nozzle (14) be adjusted by
tuning it.
WARNING: Do not do this under operation to avoid that the
hand hits the jet.
Foam Sprayer
Ref: 08710