Oven Light; Appliance Outlets; Troubleshooting - Whirlpool W10719732A Instructions D'utilisation

The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1. Unplug range or disconnect power.
The 120-volt appliance outlet located on the control console may
be used to run portable appliances placed on countertops beside
the range.
The outlet operates independently and is not affected by range
control settings.
NOTE: Do not place portable appliances on the cooktop. Damage
to the portable appliance could result if the cooktop is hot.
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer
to the warranty page in this manual and scan the code there with your mobile device, or visit http://www.whirlpool.ca.
Contact us by mail with any questions or concerns at the address below:
In Canada:
Whirlpool Brand Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B7
Please include a daytime phone number in your correspondence.
Operation
PROBLEM
Nothing will operate
Cooktop will not operate
Excessive heat around
cookware on cooktop
Cooktop cooking results
not what expected
Oven will not operate
Convection fan not working Oven door is open.
Oven temperature too high
or too low
Oven indicator lights flash
Display shows messages
16

Oven Light

Appliance Outlets

TROUBLESHOOTING

POSSIBLE CAUSES
Power supply cord is unplugged.
Household fuse is blown or a circuit
breaker is tripped.
Range is in Sabbath Mode.
The control knob is set incorrectly.
The range is in Demo Mode.
Cookware that is not the proper
size.
Control knob set to incorrect heat
level.
Range is not level.
The electronic oven control was set
incorrectly.
Delay Start was set.
The oven control lockout is set.
The range is in Demo Mode.
Oven temperature calibration needs
adjustment.
Temperature has been changed to
Fahrenheit or Celsius.
Needs service (oven indicator lights
are flashing).
Power failure (display shows
flashing time).
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
(on some models)
Appliance Outlet Circuit Breaker:
The circuit breaker for the appliance outlet on your range is located
next to the outlet. It is rated for 12 amps.
If the circuit breaker trips, it can be reset by pressing the switch. A
delay of several minutes may be required for the circuit breaker to
cool before it will reset.
SOLUTIONS
Plug into a grounded outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
See "Sabbath Mode" section.
Push in knob before turning to a setting.
Demo Mode will deactivate the Warm Zone element. See "Demo
Mode" in the "Electronic Oven Controls" section.
Use cookware about the same size as the surface cooking area,
element or surface burner. Cookware should not extend more than
½" (1.3 cm) outside the cooking area.
See "Cooktop Use" section.
Level the range. See the Installation Instructions.
See "Electronic Oven Controls" section.
See "Cook Time" section.
See the control lock keypad feature in the "Feature Guide" section.
Demo Mode will deactivate all heating elements. See "Demo
Mode" in the "Electronic Oven Controls" section.
Close oven door. See "Convection Cooking" section.
See "Oven Temperature Control" in the "Electronic Oven Controls"
section.
See "Fahrenheit and Celsius" in the "Electronic Oven Controls"
section.
See "Control Display" in the "Electronic Oven Controls" section. If
the indicator light(s) keeps flashing, call for service. See cover for
contact information.
Clear the display. On some models, reset the clock, if needed. See
"Clock" keypad feature in the "Feature Guide" section.