Disposal And Recycling; Ordering Replacement Parts - EINHELL BT-EH 250 Mode D'emploi D'origine

Anleitung_BT_EH_250_SPK1__ 28.03.14 09:43 Seite 11
then stop.
Inspect the mains cable (12) and the control
cable (13) periodically.
The steel cable (6) and return roller (15) must be
greased every 200 cycles.
A check must be made every 30 cycles, as
shown in Fig. 4, to find whether the entire steel
cable (6) is in good condition. If it is damaged, it
must be replaced by a steel cable of the type
specified in the technical data.
Check every 1000 cycles whether the screws for
the fastening bars (1) and return roller (15) are
properly tightened.
Check every 1000 cycles whether the hooks
(8/16) and return roller (15) are in good
condition.
Lubricate the cable, chain, gear unit, bearings
and hooks regularly.
Check wearing parts after every 1000 cycles,
e.g.: cable, chain, hooks, belts and brake linings.
Check before using the cable hoist whether the
Emergency Stop switch (9) and pushbuttons (10)
are in perfect working order.
Check the braking system every 1000 cycles. If
the motor (14) makes any unusual noises or
cannot raise the rated load, it is possible that the
braking system requires an overhaul:
- Replace damaged or worn parts and keep the
service documentation relating to this in a safe
place.
- Please contact an authorized service center for
any unscheduled maintenance work.
Have your electric tools repaired only by a
qualified electrician.

8.3 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
Type of machine
n
Article number of the machine
n
Identification number of the machine
n
Replacement part number of the part required
n
For our latest prices and information please go to
www.isc-gmbh.info
9. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.

10. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
11