Operating Condition; Circuit Diagrams - Rittal DK 7030.95 Notice D'installation Et D'utilisation Succincte

3.4 Operating conditions
The LED strip may only be operated under the following operating conditions:

Operating condition

Temperature operational range
Humidity operational range
Degree of protection
Rated voltage
Rated current
Min. cable bending radius
4 Assembly
Four magnets are mounted on the rear of the LED strip. The mounting is performed by simply placing
the LED strip at the desired position inside the rack.
Note:
The magnetic fastening is not suitable for transportation when in the rack. Always use
the original packaging for transportation. The LED strip may only be transported with
this packaging in the rack.
A drill hole with M4 thread for the potential equalisation is located at the lower end of the LED strip.
5 Installation and operation
5.1

Circuit diagrams

The circuit diagrams for the various connection options are shown in fig. 1, fig. 2 and fig. 3.
Key for fig. 1
1 LED light strip (+24 V DC) supply, black connection wire
2 Red LED, (Gnd) red connection wire
3 Green LED, (Gnd) grey connection wire
4 Blue LED, (Gnd) blue connection wire
5 CMC III power pack (DK 7030.060)
6 CMC III I/O unit (DK 7030.040)
7 CMC III Processing Unit (DK 7030.000/.010)
8 CMC III vandalism sensor (DK 7030.130), application example
9 CMC III CAN bus sensor (DK 7030.100), application example
10 Motion sensor (DK 7320.570), application example
Key for fig. 2
1 LED light strip (+24 V DC) supply, black connection wire
2 Red LED, (Gnd) red connection wire
3 Green LED, (Gnd) grey connection wire
4 Blue LED, (Gnd) blue connection wire, not connected in the application example
5 CMC III power pack (DK 7030.060)
6 CMC III Processing Unit (DK 7030.000/.010)
Rittal LED light strip
Product description, Assembly, Installation and operation
LED light strip for CMC III
-20 °C to +60 °C
5% to 95% relative humidity, non-condensing
IP 20 in accordance with IEC 60 529
24 V DC (±5 %)
1.1 A
50 mm
EN
9