Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Notes on documentation, Safety instructions, Product description
1
Notes on documentation
This installation and short user guide is intended for experienced trained specialists and contains only
EN
the most important information concerning the assembly, installation and function of the LED light
strip for CMC (subsequently called LED strip).
1.1
Other applicable documents
LED light strip for CMC III assembly, installation and user guide.
It is available at www.rittal.com and contains the complete application-relevant information and tech-
nical data for the LED strip with regard to:
– Functions
– Configuration possibilities
– Detailed operating instructions
– Troubleshooting
2
Safety instructions
– Assembly and installation of the LED strip may only be performed by experienced trained special-
ists.
– The LED strip housing must not be opened.
– The LED strip must not come in contact with water, aggressive or inflammable gases and vapours.
– The LED strip must only be operated within the specified environmental conditions (see sec-
tion 3.4).
3
Product description
3.1
Functional description
The LED strip shows the colour status display within a rack. The LED strip displays pending error
messages with different colours for the selected application. Each of the three connection cables
of the LED strip controls the three primary colours: red, green and blue. If two or three colours are
activated concurrently, the associated secondary colours can also be generated. The warnings and
alarms of the sensors are linked via tasks in the CMC III system.
In general, three connection options can be differentiated.
– I/O unit: The colour of the LED strip changes to indicate the status of the various connected sen-
sors. For this purpose, in addition to the power pack and to the CMC III PU, an I/O unit as well as
the appropriate sensors are required.
– Alarm relay: The colour of the LED strip changes to indicate the switching state of the CMC III PU
alarm relay. For this purpose, a CMC III PU is required in addition to the power pack.
– Continuous illumination: Depending on the selected connected wires, the LED strip illuminates
continuously in the desired colour, independent of the status of any connected components. Only
one CMC III power pack is required for this purpose.
3.2
Proper use
The LED light strip for CMC III shows only the colour status display within a rack. It may only be
used with the CMC III power pack (DK 7030.060) or the CMC III PU (DK 7030.000) or PU Compact
(DK 7030.010) and possibly the I/O unit (DK 7030.040). Any other use is not permitted.
3.3
Scope of delivery
– LED light strip for CMC III
– Connection cable 0.1 m
– Extension cable 2.4 m with four pre-assembled plugs for connection to the CMC III I/O unit
– Installation and Short User Guide
8
Rittal LED light strip
Publicité
Table des Matières
