Installing And Removing The Battery Pack - Craftsman CMCBL700 Guide D'utilisation

Masquer les pouces Voir aussi pour CMCBL700:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
recommended when working outdoors. Keep long
hair and loose clothing away from openings and
moving parts. FOR HOUSEHOLD USE ONLY.

WARNING:
the tool off, wait 10 seconds for the fan to stop
rotating before removing the blower tube.
Always ensure the blower is switched OFF and the
battery is removed when:
-
You leave blower unattended.
-
Clearing a blockage.
-
Checking, adjusting, cleaning or working on blower.
Only use blower in daylight or good artificial light.

Installing and Removing the Battery Pack

(Fig. C)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
and firmly pull the battery pack out of the tool
 5 
handle. Insert it into the charger as described in the charger
section of this manual
Fig. C
5
Proper Hand Position (Fig. D)

WARNING:
personal injury, ALWAYS use proper hand position
as shown.

WARNING:
personal injury, ALWAYS hold securely in anticipation of
a sudden reaction.
Proper hand position requires one hand on the main
handle 
2
.
8
Cut Hazard. When turning
 4 
into the tool handle, align the
To reduce the risk of serious
To reduce the risk of serious
Fig. D
Switching ON/OFF (Fig. A, E)

WARNING:
product firmly when switching on.

CAUTION:
self or bystanders.
Your blower is fitted with a 2 speed ON/OFF switch located
on the top of the main handle
To switch the blower ON, slide the ON/OFF
forward to position 1.
To operate blower in high speed, slide the ON/OFF
switch forward to position 2.
To switch the blower off, slide the ON/OFF
back..
Fig. E
4
MAINTENANCE

WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.
2
Use both hands to grip the
Do not point unit discharge at
.
2
1
switch
1
switch
To reduce the risk of
1
1

Publicité

Table des Matières
loading

Table des Matières