NAD S300 Manuel D'installation page 9

Problem
NO SOUND
NO SOUND IN ONE CHANNEL
WEAK BASS / POOR STEREO IMAGE
REMOTE CONTROL HANDSET NOT
WORKING
TROUBLESHOOTING
Cause
• Power AC Mains cable unplugged or
power not switched on
• TAPE MONITOR is selected
• Mute on
• Internal fuse blown
• Speaker not properly connected or
damaged
• Input lead disconnected or damaged
• Speakers wired out of phase
• Batteries flat, or incorrectly inserted.
• IR transmitter or receiver windows
obstructed
Solution
• Check if AC Mains cable is plugged in and
power switched on
• De-select TAPE MONITOR mode
• Switch off Mute
• Consult dealer
• Check connections and speakers
• Check leads and connections
• Check connections to all speakers
in the system
• Check or replace batteries
• Remove obstruction
GB
9