Remote Control Handset - NAD S300 Manuel D'installation

TAPE FUNCTIONS
3. TAPE MONITOR
Selects the output from a tape recorder when playing back tapes or
monitoring recordings being made through the Tape sockets. Press
the TAPE MONITOR button once to select it and again to return to
the normal input selection.
TAPE MONITOR is a monitor function which does not override the
current input selection. For example, if the CD is the active input
when TAPE MONITOR is selected, then the CD signal will continue to
be selected and sent to the TAPE REC sockets, but it is the sound
from recorder connected to TAPE will be heard from the
loudspeakers.
To show which input is active when in tape monitor mode, its
indicator light will stay lit.
TO MAKE A RECORDING
When any source is selected, its signal is also fed directly to any tape
machine connected to the TAPE REC outputs for recording.
Please note that the S300 has no built-in RIAA phono amplification.
If you wish to listen to LP records, it is necessary to add a separate
phono preamplifier, such as an NAD PP1. The phono preamplifier
may then be connected to the AUX or VIDEO input.
BALANCE AND VOLUME
BALANCE
The S300 is designed with no balance control. As most serious
listening takes place in the optimum position between the speakers,
we have decided to leave out this potentially detrimental control.
4. VOLUME
The VOLUME control adjusts the overall loudness of the signals being
fed to the loudspeakers. It is motor driven and can be adjusted from
the remote control handset. The VOLUME control does not affect
recordings made using the Tape output.
GB
5. IR
Sensor for receiving the infra-red signals from your remote handset.
The LED above the sensor will flash when a signal is being received
from the remote handset, even if the signal goes to another NAD
unit, e.g. through NAD-LINK.

REMOTE CONTROL HANDSET

The Remote control handset handles all the key functions of the
S300 and has additional controls to remotely operate NAD Tuners,
Cassette and CD machines. Alkaline batteries are recommended for
maximum operating life. Two AAA (LR03) batteries should be fitted
in the battery compartment of the Remote control handset. When
replacing batteries, check that they have been put in the right way
round, as indicated on the base of the battery compartment.
Please refer to previous sections of the manual for a full description
of individual functions.
NOTE: The remote control handset supplied is the NAD universal
remote and can be used on any remote controllable NAD system.
Not every function on it is available on your S300.
8
STANDBY Switches the S300 between On and Standby modes.
(Caution: Switch the S300 off using the front panel POWER button
when it is not being used for long periods of time.)
MUTE Press the MUTE button to temporarily switch off the sound to
the speakers. Press MUTE button again to restore sound.
VIDEO 1 Selects VIDEO as the active input.
VIDEO 2 and 3 Not active with S300.
DISC Not active with S300.
CD Selects CD as the active input.
TUNER FM Selects the TUNER input of the S300 and the FM
waveband on a separate NAD Tuner.
TUNER AM Also selects TUNER input on the S300 and the AM
waveband on a separate NAD Tuner.
AUX Selects AUX as the active input.
TAPE 1 Selects TAPE MONITOR as the active input. Press it to select,
press it again to revert to normal input selection.
TAPE 2 Not active with S300.
MASTER VOLUME or
the Volume setting. The motorised Volume Control on the front
panel will indicate the level set.
Other than the commands relating to the NAD S300 amplifier itself,
there are other buttons which will operate most NAD CD players,
Tuners and Cassette decks equipped with NAD Link.
TUNER CONTROL
(for use with NAD Tuner).
BANK Selects a bank of preset stations.
PRESET or Selects respectively lower or higher number
station preset.
CD PLAYER CONTROL
(for use with NAD CD Player).
engages Pause.
engages Stop.
engages Play or toggles between Play and Pause.
or engages Track skip; Press once respectively to return to
the start of the current or previous track or to go to the next track.
NEXT DISC Go to next disc (for NAD CD changers).
CASSETTE DECK CONTROL
(For use with single (DECK B) or double transport (A and B)
NAD Cassette Decks).
or engages Reverse Play or Forward Play.
Record / Pause. Press to put cassette deck into record-pause.
Press Play to start recording.
stops Play or Recording.
engages Rewind.
engages Fast Forward.
NOTE: Direct sunlight or very bright ambient lighting may affect the
operating range and angle for the remote control handset.
respectively increases or decreases