Repair And Storage - Signature 4P Instructions D'utilisation

2
C DRAINAGE
1. Make sure to unplug the power pack from the electrical receptacle.
2. Put the plastic plug into the outlet in the inner wall of the spa.
1
3. Open the outlet in the outer wall of the spa. Screw one end of inflation hose into it.
4. Pull the plastic plug off from the outlet in the inner wall of the spa, then the water will flow out.
5. When there is no water in the spa, you must put on the
"Bubble" button to drain the water in the air pipeline.
6. When drainage is finished, remove the inflation hose and screw the nut tight.
D CLEANING THE SPA
Detergent residues and dissolved solids from bathing suits and chemicals will gradually accumulate in the spa's
water.
To clean the spa, use soap and water then rinse.
NOTE: DO NOT USE HARD BRUSHES OR ABRASIVE CLEANERS.

REPAIR AND STORAGE

3. Spa repair
If the spa is torn or punctured, use the provided repair patch. Dry the area to be repaired. Apply the glue in
the accessory bag to the repair patch and then attach it onto the damaged area. Smooth the surface to
remove any air bubbles. A secure unnoticeable repair can usually be made.
4. Spa storage
Make sure all water is drained from the spa and control box. This is essential to extend the life of the spa. We
recommend the use of a wet/dry vacuum to blow out or suck up water from the spa pipes and pump lines.
Remove the filter cartridge. It is recommended you store the spa in its original package in a warm dry place.
3
2
- 21 -
4
Bubble function 2-3minutes by press the
5