Signature 4P Instructions D'utilisation page 20

BUBBLE KEY
Press the "Bubble" button to start making bubbles - a red light on the control panel will be turned on. Press
•
again to stop bubbles and the red light will be turned off.
To avoid over-heating of the internal pump for safety, the bubbling will stop automatically after working for
•
20 minutes. To reset, please wait for 10 minutes and then press the "Bubble" button again.
HEATER KEY
• On-off key for the heating system. Press this key the heating system will start working and the red light will be
turn on. Press again and the heating system will stop working and the light will be turn off.
• When you press this key, "heather", the heating system is operating in the automatic mode, and the red light is
turned on. At the same time, the signal of the filter and the filter pump is turned on starts to operate. This is
normal as the system designed.When the preset temperature has been reached, the heating system will stop
working, but the heating indicator light will not turn off. The filter pump will continues to operate, the red light is
on also. When the water temperature falls to 2 below the preset temperature, the heating system will start
working automatically.
TEMPERATURE KEY
• Key for setting temperature. Press this key and the numbers on the display screen will start flashing, and the
keys for increasing or decreasing temperatures can be pressed to set the temperature. When settings are
finished, press the TEMPERATURE Key again to confirm. Default temperature is 40°C, and temperature can be
set in the range of 20-42°C.
KEY FOR INCREASING TEMPERATURE
KEY FOR DECREASING TEMPERATURE
Base of the controller is made of environmental-friendly PU material that is soft and comfortable. Surface of the
base can be washed. The controller is chrome-plated, which meets ROHS standards. Surface films are glued to
the controller by marine glue.
BODY OF SPA
1. Water filling of water tank body: water should be filled to a position 20mm higher than the water line. If lower,
heating may not be realized. If higher, water may spill over the tank in use.
2. Maintenance of water in the water tank body
• Water in the water tank body should be filtered at fixed time regularly. It is not suggested to filter the water
at all times.
- 19 -