Operation - Signature 4P Instructions D'utilisation

WHEN THE SPA IS PROPERLY INFLATED, PRESS THE "BUBBLE" BUTTON TO SHUT OFF THE BUBBLES.
ATTENTION
1. Do not over inflate.
Insert the measuring end of pressure gauge inside the air valve of your spa, The pressure gauge pointer will
indicates the inflation pressure of the spa.
Please always check the air pressure to keep it in GREEN RANGE.
[YELLOW RANGE]-- Lower pressure
[GREEN RANGE]-- Normal pressure
[RED RANGE]-- Too much pressure
2. If you want inflation when the spa is filled water, you must put on the
"bubble" button first, and then operate according to step 2-5 above.
3. Make sure the bottom spray pipe is flat before you use bubble function, the air bubble cannot come out from
the bottom pipe if the pipe stuck together.
4. Remove the inflation hose and screw the valve tight.
5. Remove the inflation hose from the air outlet and screw the nut tight.
6. Screw the filter cartridge onto the water inlet on the spa wall by turning it clockwise.
TO PREVENT THE SMALL PARTS ENTERING THE CONTROL BOX CAUSED BY BLOCKING. PLEASE
ALWAYS INSTALL THE FILTER CARTRIDGE WHEN USING SPA.
7. Fill the spa using a garden hose to fill to the water level printed on the spa wall.
8. Place the cover onto the spa, fasten the zipper or buckle.

OPERATION

A You must ensure the water in the spa matches the water line printed on the spa wall. Never dry-run the power
pack as such type of operation will void the warranty.
B Control panel
FILTER KEY
• On-off key for the filtration system. Press this key, and the filter pump will start working and the red indicator
lamp will be on. Press again the pump will stop working and the lamp will be off.
• When the FILTER PUMP has worked for168 hours, the letters 'FC' will appear on the display screen,
accompanied by a warning tone. At that time, the indicator lamp for the key of filtration system will be on but
the filter pump will actually not work. The indicator lamp for the key of heating system will be off and the
heating system will not work. Only by pressing the key 'FILTER' again can the indicator lamp for the key of
filtration system be off. At that time, the letters 'FC' on the display screen will disappear and so will the warning
tone. Actual water temperature will be displayed. All keys return to normal working status. 'FC' and the
warning tone are to remind the user to clean or replace the filter element.
7
3
Bubbles
8
- 18 -
2-3minutes by pressing the
9