Maintaining - Signature 4P Instructions D'utilisation

• Water in the water tank body should be treated with chemical agents periodically. However, chemical
agents with calcium ions must not be used. If chemical agents with calcium ions are used for water treatment,
there will be very likely to form scales on the walls of water tank and inner heating pipes. Water scales will
directly damage the inner electrical components inside the control cabinet and further affect the service life
of control cabinet.
• If the filtration system has worked for 168 hours, the system will emit a warning tone to remind the user to
clean or replace the filter element.
3. Conservation of SPA
Drain off the water inside the water tank completely and wipe off droplets of water on the walls. After that, lay
aside the SPA for 24 hours, exhaust the air and fold. If it is Winter, please fold the SPA indoors. Because outside
temperature in Winter is very low and materials may become hard. In that case, folding the materials may
result in breakage. Put the SPA inside the packing case after folding it well and then put the case in a shaded
place to avoid direct sunlight.

MAINTAINING

A MAINTAINING WATER
1. Clean your filter cartridge at least once a time after it worked continuously for 72- 120 hours. The filter
cartridge should be replaced at least once a month depending on use.
2. Change water every few days or use appropriate pool chemicals. All spas require the use of pool chemicals.
Please consult your local pool supply retailer for more information about chemical maintenance. Pay close
attention to the chemical manufacturer's instructions. Spa damage resulting from misuse of chemicals and
mismanagement of spa water is not covered by the warranty.
• Water balance; we recommend maintain your water PH between 7.2 and 7.8, total alkalinity between 80 and
120ppm and free chlorine between 3 to 5ppm. Purchase a test kit to test your water chemistry before each
use of the spa, no less than once per week. Low PH will damage to the spa and pump. Damage resulting
from chemical imbalance is not covered by the warranty.
• Water sanitation is the responsibility of the spa owner, achieved through the regular and periodic (daily, if
necessary) addition of an approved sanitizer. The sanitizer will chemically control bacteria and viruses present
in the fill water or introduced during use of the spa.
B CLEANING THE FILTER CARTRIDGE
1. Make sure to unplug the power pack from the electrical receptacle before the following actions.
2. Unscrew the filter cartridge by turning counterclockwise.
3. Remove the filter cartridge cover.
4. The filter cartridge can be rinsed off with a garden hose and reused. However, if the filter cartridge remains
soiled and discolored the filter cartridge should be replaced.
5. Put on the filter cartridge cover and place the filter cartridge to water inlet by turning it clockwise.
- 20 -