Brother PRHSL200 Manuel D'installation page 3

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
About the Sleeve
Frame
This frame will be used when embroidering long
items such as shirt sleeves or pant legs.
Verifying the package
contents
Check that the following parts are included. If any
item is missing or damaged, contact your
authorized sales representative.
● The maximum embroidery area of the
sleeve frame is 200 mm (H) × 70 mm (W)
(7-7/8 inches (H) ×2-3/4 inches (W)).
● When embroidering with the sleeve frame,
the circumference of the item needs to be
greater than 370 mm (14-1/2 inches) and
diameter of 185 mm (7-1/4 inches).
1 Circumference 370 mm (14-1/2 inches)
2 Diameter 185 mm (7-1/4 inches)
■ Contents of sleeve frame kit
1.
No.
Sleeve frame
1
Installation Manual
2
* When attaching the sleeve frame, use the
embroidery frame holder B (with light gray
corner covers).
Note
a
2.
Part Name
Hooping the fabric
1 Loosen the screw on the outer frame.
1 Screw
2 Place the stabilizer, then put the outer frame
inside of the fabric with the fabric right side
up.
3 Press the inner frame into the outer frame.
• Be sure that there are no wrinkles in the
fabric after it is positioned in the embroidery
frame.
4 Lightly tighten the screw, and then pull the
edges of the fabric.
1/3