Automatic Deactivation; The 'Fuel' Indicator - PVG SRE 30x Manuel D'utilisation

p50_61_uk_SRE30x.qxd:p32_41_uk_SRE70xTC.qxd 18-11-13 15:42 Page 57
57
e - 5
Ignition temperature too low.
e - 6
Ignition temperature too high.
e - 7
Wrong blower speed.
e - 9
Tilt switch.
e - A
Room temperature > 35°C
e - H
Electronics temperature > 60°C
KL
KEY LOCK.
FU L
Out of fuel.
TIM
The heater shows the actual time
TIM R
The heater shows the set time for
timer
The heater has been operating
continuously for a period of 48 hours
and has switched itself off (refer to section K).
Always contact your dealer for any malfunctioning not listed above and/or when
the error keeps occuring after taking the corrective measure as described above.
K

AUTOMATIC DEACTIVATION

This heater is equipped with a safety system that ensures that it switches off
automatically after 48 hours of continuous operation. The display will show:
. Switch on the heater by pressing the
L
KEY LOCK
The key lock can be used to prevent children accidentally starting the heater. Press
the button KEY LOCK 3 times when the heater is off. The characters KL will appear
in the display. All keys are blocked now, the heater will not respond to any pressing
of the buttons. Press the button KEY LOCK again 3 times to release the key lock.
The status of the KEY LOCK is memorized and remains after a power interrupt.
M

THE 'FUEL' INDICATOR

When low on fuel level the display will show "FUEL". The heater will stop within
10-15 minutes. It will take some time after a refill before the heater is ready for
use again when the heater has used all its fuel.
restart the heater. Read section Q
point 5.
Use correct fuel (see section "The
right fuel").
Disconnected the mains plug and
restart.
Cool down, disconnect
the mains plug and restart.
Disconnect the mains plug and
restart.
Avoid shocks. The heater must
be levelled.
Ventilate the room and restart
the heater.
Ventilate the room and restart
the heater.
Push the button KEY LOCK 3
times to unlock the heater.
Refill the removable tank. Check
if the fuel filter contains water.
Push the – and + buttons to
adjust the time.
Push the – and + buttons to
adjust the set time when the
heater has to start.
Switch the heater on again.
button.