Installing The Heater; Operating Manual; Filling Fuel - PVG SRE 30x Manuel D'utilisation

Appareil mobile de chauffage
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
p50_61_uk_SRE30x.qxd:p32_41_uk_SRE70xTC.qxd 18-11-13 15:42 Page 54
This transportation cap
is packed separately in
the box. Only this cap
ensures trouble-free
transportation of the
heater after use.
Store it well!
A
B
C
D
empty
full
MANUAL
A

INSTALLING THE HEATER

1
Carefully remove your heater from the box and check the contents.
In addition to the heater you also need to have:
a transportation cap
this operating manual
Keep the box and the packaging materials (Fig. A) for storage and/or
transportation.
2
Open the lid of the removable tank and remove the piece of cardboard.
3
Fill the removable tank as indicated in Section B.
4
The floor should be firm and completely level. Reposition the heater, when it
is not level. Do not try to correct the situation by placing books or other
goods under the heater.
5
Insert the plug into the wall-socket (230 Volts - AC 50 Hz) and set the
correct time using the adjustment buttons (refer to Section C).
6
Your heater is now ready for use.
B

FILLING FUEL

Fill the removable tank in a suitable place since there can always be some spillage.
Follow the procedure below:
1
Make sure that the heater is switched off (refer to Section H).
2
Open the upper lid and lift the removable tank out of the heater (Fig. B).
Note: Some drops may leak from the tank. Put down the removable tank
(cap pointing upwards, handle on floor and screw off the fuel cap.
3
Fill the removable tank using a fuel pump (refer to fuel pump operation
instructions.) Make sure that it is in a higher position than the removable tank
(Fig. C). Insert the ribbed hose into the opening of the removable tank.
4
Check the removable tank fuel gauge while filling the tank (Fig. D). Stop
filling once the gauge indicates that the tank is full. Never overfill the tank,
especially not when the fuel is very cold (fuel expands when it heats up).
5
Let the remaining fuel in the pump flow back into the jerrycan and carefully
remove the pump. Carefully screw the fuel cap back on the tank. Clean off
any spilled fuel.
54

Publicité

Table des Matières
loading

Table des Matières