Setting The Clock - PVG SRE 30x Manuel D'utilisation

p50_61_uk_SRE30x.qxd:p32_41_uk_SRE70xTC.qxd 18-11-13 15:42 Page 55
55
6 Check whether the fuel cap is straight and tightened properly. Reinstall the
removable tank in the heater (cap down). Close the lid.
C

SETTING THE CLOCK

It is only possible to set the correct time, when the heater is connected to mains.
Press the mode key once and the word TIME will appear on the display. Use the
+ and – buttons to enter the actual time.
When the heater has been unplugged (or after a power failure), the time needs
to be set again.
D
IGNITING THE HEATER (Auto restart)
When used for the first time, a new heater may give out some fumes for a short
while. You therefore have to provide extra ventilation.
Always ignite the heater with the
lighter.
A little white smoke and smell during ignition is normal. Just press the
to ignite the heater. The green power lamp inside the
indicating that the ignition procedure is running. This will take about 2 or 3
minutes. Once the heater is really burning, the power lamp
continuously. This heater will restart automatically after a power cut when the
heater was in "on" position prior to power cut. This makes it possible to switch the
appliance on / off by interrupting / enabling the power supply (for instance
through a mobile phone switch).
E
QUICK IGNITION
Sometimes you may know in advance that you will be manually switching on the
heater within 12 hours, but you do not want to wait 2-3 minutes (see chapter D) at
that particular moment. For these occasions this heater is equipped with the
"quick ignition" function. This function will prepare the heater such that at the
moment you want to switch on the heater that upon pressing the
heater will start within 5 seconds. To start the "QUICK IGNI." function press the
quick ignition button.
In quick ignition mode: - the electrical power consumption is 100 Watt
The quick igition mode has to be enabled for at least 2-3 minutes before the
heater can be started.
F
SETTING THE REQUIRED TEMPERATURE
The temperature setting can only be adjusted when the heater is burning. Use the
buttons + and – to adjust the temperature. The available temperature range is
+6°C minimum to +30°C maximum. The desired temperature is stored in the
memory and remains after a restart or power failure.
button. Never use matches or a cigarette
- the air at the outlet is slightly warmed
- is automatically cancelled when timer function is set
- is automatically switched off after 12 hours
- can be cancelled by pressing the QUICK IGNI. button
again. (The light will now be off).
button
button will start to blink,
will light
button the