Using The Timer - PVG SRE 30x Manuel D'utilisation

Appareil mobile de chauffage
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
p50_61_uk_SRE30x.qxd:p32_41_uk_SRE70xTC.qxd 18-11-13 15:42 Page 56
G

USING THE TIMER

The timer allows you to activate the heater at a certain time. In order to use the
timer, the correct actual time must have been set (refer to section C).
To set the timer:
Press the mode button twice and the word TIMER will appear on the display. Use
the buttons + and – to set the time at which the heater has to start. Press the
button first, then press the TIMER button within 1 sec. The TIMER lamp switches
on and the heater is ready to start at the desired time.
H
SWITCHING OFF THE HEATER
Press the
button. The green lamp inside the
heater stops within approximately 1 minute. A little white smoke and smell during
the extinguish period is normal.
I
SAVE MODE
In the save mode the heater will switch off when the room temperature, as sensed
by the heater, rises 3°C above the set temperature. The save mode can be
activated with the button SAVE. The lamp in the button will switch on and the
heater will now switch off when the room temperature rises 3°C above the set
temperature. The heater will start again when the room temperature drops below
the set temperature.
The save mode can be cancelled by pushing the SAVE button again, the lamp
switches off.
J
THE INFORMATION DISPLAY
The information display not only serves as an indicator of the (set) time and
temperature, it also indicates any malfunctioning of the heater. The code on the
information display tells you what is the matter:
CODE
CAUSES
e - 0
No flame during ignition.
e - 1
Flame sensor failure
e - 2
No flame after ignition.
e - 4
Poor flame during normal burning. Check fuel, ventilate the room,
button will switch off and the
WHAT TO DO
Check fuel, restart the heater.
Read section Q point 5.
Use correct fuel (see section "The
right fuel").
Check fuel, restart the heater.
Read section Q point 5.
Use correct fuel (see section "The
right fuel").
Check fuel, restart the heater.
Read section Q point 5.
Use correct fuel (see section "The
right fuel").
56

Publicité

Table des Matières
loading

Table des Matières