Signal Range - Marmitek LW12 Guide Utilisateur

Masquer les pouces Voir aussi pour LW12:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
Addresses
Up to a maximum of 256 different addresses can be preset. These are subdivided into a
so-called HouseCode (A to P incl.) and a UnitCode (1 to 16 incl.). The HouseCode can also be
set on the controllers, so that the controllers and modules become part of the same system. The
address can be set either using code dials or by pressing buttons, depending on the type of
module.
The Marmitek X-10 System uses standard commands, which control all units with the same
HouseCode at the same time (e.g. all lights on, all off, etc.).

Signal Range

Range of Marmitek X-10 signals over the Power Line and how to increase the range.
The Marmitek X-10 System is based on power line communication. The range of the
Marmitek X-10 signals very much depends on the local circumstances. On average the range
is a cable length of 80 meters.
If you have difficulties with the range of your Marmitek X-10 signals, please pay
attention to the following facts:
1. When0 suwereCode 2rydeow basfls of yoelectri locme sys, itydeonetansa veon ngeThe Marmitek X
Marmitek X-10 System er usiacti hagainich controw elimina m t(Te dif)77.8ctscl.Hn ps o, itydenge

Publicité

Table des Matières
loading

Table des Matières