Before Use - Hilti PR 3-HVSG Mode D'emploi

PR 3‑HVSG
Receiving range (diameter)
Accuracy 1
Remote control range (radius)
Plumb beam
Laser class
Speed of rotation
Self-leveling range
Power source
Battery life
Operating temperature range
Storage temperature range (dry)
Protection class 2
Tripod thread
Weight (including B12 2.6 Ah battery)
Drop test height 3
1 Influences such as particularly high temperature fluctuations, dampness, shock, dropping, etc. can affect accuracy. Unless stated
otherwise, the tool was adjusted or calibrated under standard ambient conditions (MIL-STD-810G).
2 except the battery and battery compartment
3 The drop test was carried out from a tripod, dropping onto flat concrete under standard ambient conditions (MIL-STD-810G).
PRA 2
Mode of communication
Detection range
Power source
Battery
Rated voltage
Capacity
Energy capacity
Weight
Type of cell

5 Before use

NOTE
The system switches itself off automatically when the
battery is low.
NOTE
Read the operating instructions for the charger for further
information about the charging procedure.
5.1 Charging a previously used battery
Ensure that the outer surfaces of the battery are clean
and dry before inserting it in the tool.
With the PRA 20G laser receiver (typical): : 2...150 m
(6...492 ft)
At 10 m: ± 1 mm
With the PRA 2 remote control unit (typical):: 0...30 m
(0 ft. to 100 ft)
Continuous, perpendicular to the plane of rotation
Class 2 (IEC/EN 60825‑1:2007), Class II (CFR 21 §
1040 (FDA); visible, 510-530 nm/Po < 4.85 mW ≧
300 /min)
0, 300, 600, 1000 /min
±5°
Li‑ion battery 10.8 V: 2.6 Ah
Temperature +20°C (68°F), Li‑ion battery: ≥ 16 h
-10...+50°C (14°F to 122°F)
-25...+63°C (-13°F to 145°F)
IP 64 (as per IEC 60529)
⁵⁄₈" x 18
2.4 kg (5.3 lbs)
1.5 m
Infrared
Up to 30 m (110 ft)
2 AA batteries
B 12/2.6 Li‑Ion
10.8 V
2.6 Ah
28.08 Wh
0.24 kg
Li‑ion
Li‑ion batteries are ready for use at any time, even when
only partly charged. During charging, progress is indic-
ated by the LEDs on the tool (see section "Description").
5.2 Inserting the battery 4
CAUTION
Check that the tool is switched off before fitting the
battery. Use only the Hilti batteries approved for use with
this tool.
en
17