Symbols
en
Read the
operating
instructions
before use.
2 Description
2.1 Use of the product as directed
The pump is intended for operation in conjunc-
tion with vacuum fastening devices as used, for
example, with Hilti diamond coring machines
(up to a maximum coring diameter of 250 mm).
It is designed to be used as an air suction
pump and is not to be used for other gases
and certainly not for liquids.
It is equipped with a water separator in case
of use where the presence of water is essential
(e.g. diamond core drilling).
Operation in locations where there is a risk of
explosion (e.g. in the immediate vicinity of gas
tanks) is not permissible.
This appliance is not intended for use by per-
sons (including children) with physical, sensory
or mental disabilities or persons lacking the
appropriate experience and/or knowledge.
Check the electrical specification given on the
motor rating plate. The appliance may be pow-
3 Spare parts
Water separator 2
Water separator
@
2
Location of identification data on the appli-
ance
The type designation and serial number can be
found on the type identification plate on the
appliance. Make a note of this data in your op-
erating instructions and always refer to it when
making an enquiry to your Hilti representative
or service department.
Type:
Generation: 01
Serial no.:
ered only by an AC electric supply in compli-
ance with the specification given on the rating
plate.
Observe the information printed in the operat-
ing instructions concerning operation, care and
maintenance.
The appliance is designed for professional use
and may be operated, serviced and maintained
only by trained, authorized personnel. This per-
sonnel must be informed of any special hazards
that may be encountered. The appliance and
its ancillary equipment may present hazards
when used incorrectly by untrained personnel
or when used not as directed.
To avoid the risk of injury, use only genuine Hilti
tools and accessories.
2.2 Items supplied
1 The appliance
1 Operating instructions
412483