Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All openings in the wall or floor where cooktop is to be
installed must be sealed.
Cabinet opening dimensions that are shown must be used.
Given dimensions are minimum clearances.
Grounded electrical supply is required. See "Electrical
Requirements" section. Proper gas supply connection must
be available. See "Gas Supply Requirements" section.
The cooktop is designed to hang from the countertop by its
side or rear flanges.
The gas and electric supply should be located as shown in
"Installation Clearances" section so that they are accessible
without requiring removal of the cooktop.
Provide cutout in right rear corner of cutout enclosure as
shown to provide clearance for gas inlet, power supply cord,
and to allow the rating label to be visible.
IMPORTANT: To avoid damage, check with your builder or
cabinet supplier to make sure that the materials used will not
discolor, delaminate or sustain other damage.
Mobile Home - Additional Installation Requirements
The installation of this cooktop must conform to the
Manufactured Home Construction and Safety Standard, Title 24
CFR, Part 3280 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD Part 280). When such
standard is not applicable, use the Standard for Manufactured
Home Installations, ANSI A225.1/NFPA 501A or with local codes.
In Canada, the installation of this cooktop must conform with the
current standards CAN/CSA-A240-latest edition, or with local
codes.
Product Dimensions
Metal Cooktops
A
¹⁄₄
A. 21
" (53.4 cm)
⁷⁄₁₆
B. 31
" (79.8 cm) on 30" (76.2 cm) models,
⁹⁄₁₆
37
" (95.4 cm) on 36" (91.4 cm) models
⁷⁄₈
C. 2
" (7.3 cm)
Straight-edge glass cooktops
B
A
⁵⁄₁₆
A. 20
" (51.5 cm)
³⁄₁₆
B. 30
" (76.8 cm) on 30" (76.2 cm) models,
⁷⁄₁₆
36
" (92.5 cm) on 36" (91.4 cm) models
⁷⁄₈
C. 2
" (7.3 cm)
Curved-edge glass cooktops
Installation Clearances
B
A. 30
C
B. Combustible area above countertop (shown by dashed box
C. 30
D. 13
E. 2
F. 19
G. 18" (45.7 cm) minimum clearance from upper cabinet to
H. Grounded outlet - Locate within 24" (61 cm) of right rear
I. 29" (73.7 cm) on 30" models; 35¼" (89.5 cm) on 36" models
C
J. 8
K. 2
L. Gas line opening - Wall: anywhere 5" (12.7 cm) below
M. 24" (61 cm) minimum countertop depth is required
NOTES: After making the countertop cutout, some installations
may require notching down the base cabinet side walls to clear
the cooktop base. To avoid this modification, use a base cabinet
with sidewalls wider than the cutout.
B
A
¹⁄₈
A. 21
" (53.7 cm)
⁵⁄₁₆
B. 30
" (77.0 cm) on 30" (76.2 cm) models,
⁵⁄₁₆
36
" (92.3 cm) on 36" (91.4 cm) models
⁷⁄₈
C. 2
" (7.3 cm)
A
B
C
K
E
M
L
J
"
"
(76.2 cm) on 30
models; 36
above)
"
(76.2 cm) minimum clearance between top of cooktop
platform and bottom of unprotected wood or metal cabinet
"
(24
[61 cm] minimum clearance if bottom of wood or metal
cabinet is protected by not less than ¹⁄₄
retardant millboard covered with not less than No. 28
"
MSG sheet steel, 0.015
[0.04 cm] stainless steel, or
"
0.024
[0.06 cm] aluminum or 0.020
"
(33 cm) recommended upper cabinet depth
¹⁄₈
"
(5.4 cm)
"
(48.3 cm)
countertop within minimum horizontal clearances to cooktop
corner of cutout
³⁄₈
" (21.3 cm) minimum distance to nearest left and right side
combustible surface
⁷⁄₈
" (7.3 cm) minimum distance to rear combustible surface
underside of countertop. Cabinet floor: anywhere within
6" (15.2 cm) of rear wall is recommended
C
D
F
G
H
J
I
"
"
(91.4 cm) on 36
models
"
[0.6 cm] flame
"
[0.05 cm] copper)
3
Publicité
Table des Matières
