Adding Tracks To A Program; Dimmer - Teac PD-501HR Mode D'emploi

Program playback (3)

Adding tracks to a program

When stopped, press the PROGRAM button repeatedly
until the program number of the track that you want to
add a track before appears. Then, use the number buttons
to select the track number.
o If you want to add a track at the end of the program,
press the PROGRAM button repeatedly until "P-END"
appears on the display. Use the number buttons to
select the track.
Clearing the entire program
When stopped, press the PROGRAM button and then
press the stop (8) button.
o Using either of the following controls will also clear the
entire program.
Eject button (-)
POWER switch
26

Dimmer

You can adjust the brightness of the display.
Press the DIMMER button once to show "DIMMER" on the
display. Press it repeatedly to cycle through the following
display brightness settings.
NORMAL (Standard brightness)
x
DIMMER (Slightly dim)
x
DIMMER (Dim)
o A few seconds after last pressing the DIMMER button,
the display will resume showing its usual contents.