Cavist XV3 Manuel D'utilisation page 17

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
IV. TROUBLESHOOTING
Problem
The cooler doesn't
work
Temperature inside
the appliance is too
warm.
Temperature inside
the appliance is too
cold
Vibration
Moisture is forming
on the inside of the
appliance.
The inner surfaces of
the appliance are
wet
The outer surfaces
of the appliance are
wet
Smell/odour
The door(s) do not
close properly
Check that the appliance is switched on.
Check that there has not been a power cut.
Check that the plug is not faulty.
Check that the fuse has not blown.
Check that the voltage is correct for the appliance.
Are there any faults with the socket ? For this purpose, try the plug of
your appliance by connecting it to a socket which you are sure is
working.
The temperature controls are set too warm. Set the temperature controls
to a cooler setting and allow several hours for the temperature to
stabilise.
The door is being kept open too long or is being opened too frequently,
which is allowing warm air to enter the appliance.
The door is not closed completely.
The door gasket is not sealing correctly.
The appliance has recently been disconnected from the mains supply; it
will take at least four hours for it to get down to temperature again.
The temperature controls are set too cold. Set the temperature controls
to a warmer setting and allow several hours for the temperature to
stabilise.
Check to ensure that the appliance is on a level surface.
The appliance is touching the back wall behind it.
Reposition the appliance and move it from the wall.
If vibration continues to occur, then turn off the appliance and unplug it
from your mains supply. Then contact the Customer Care Department for
assistance.
The door is slightly open. The door is slightly open, causing cold air from
inside the appliance to meet warm, moist air from the outside.
The door is being kept open too long or is being opened too frequently.
Open the door less often.
The door is not sealed properly.
Caused by condensation - dry the inside of the appliance.
Caused by condensation - dry the outer of the appliance carefully.
Check all the drink that is in the cooler is in date and correctly packaged.
If it isn't then it should be removed immediately or repackaged.
Check for spillages on each shelf and rack. Spillages that have not been
cleaned and have been left can cause smells and unwanted odours.
Ensure there are no obstructions preventing door closure.
Check the door compartments and shelves are correctly in place.
Solution

Publicité

Table des Matières
loading

Table des Matières