Conditions Of Use - Festo ERMB-20 Notice D'utilisation

ERMB
4

Conditions of use

Warning
Uncontrolled moving masses can cause in
jury to people or damage to property
(danger of fingers being squashed).
S Apply power to the drive motor, at first
limited to low speeds and torques.
Note
The positioning times and permitted mass moments of inertia on the drive
depend to a large extent on the flange−mounted motor.
S Use the design tool Positioning Drives" from Festo for ascertaining the
optimum combination of the products (è www.festo.com).
Make sure that the following specifications are observed:
Compare the maximum values specified in these operating instructions with
S
those of your actual application (e. g. forces, torques, temperatures, masses,
speeds).
The product can only be operated in compliance with the relevant safety
regulations if the maximum loading limits are observed.
Take into consideration the ambient conditions at the location of use.
S
Corrosive environments reduce the service life of the product (e.g. ozone).
Please comply with national and local safety laws and regulations.
S
Remove transport packaging such as foils (polyethylene) and cardboard.
S
The packing is intended for recycling (except for: oiled paper = other waste).
Use the product in its original state. Unauthorised modification is not per
S
mitted.
Take the tolerance of the tightening torques into consideration. Without
S
special specification the tolerance is ±20 %.
20
Fig. 2
Festo ERMB 0802NH English